Support: How to switch from one operator to two operators

Keywords: one operator two operators

  • First switch to  the primary trio

  • Let's start by Importing a new keyboard file

  • Open up the trio client and click configure in the upper left corner

  • Click on Keyboard Shortcuts in the left navigation window and then "Import"

  • Click on the folder icon

  • Navigate to C:/Drivers/viz/2_trio/viz28/ and select the appropriate file in the keyboard folder

  • Click the "Import" button to load the new keyboard file

  • Now lets delete the "c" channel

  • Click on External Output Channels

  • Then click on the third entry under Available Viz Hosts and then click  "Delete"

  • Now switch to the secondary engine

  • Note the bullet number of the engine

  • Edit the startup batch file by going to Start > Programs > Startup right click on map-tv.bat and click Edit

  • Change the EnginePath to point to the current engine

  • set EnginePath=\\rcg-engine-xx\Trio-Data

  • Where xx is the current bullet number

  • Now run the batch file by going to Start > Programs > Startup > map-tv.bat

  • Your bullets are now configured for two operators

 

Click the link below to see how to change to a 2 engine, 1trio, one operator setup

How to set up 2 engines and 1 trio for one operator


Applies to Bullet: